Q-See H.264 NETWORK DVR User Manual page 29

Definitions and descriptions of network configuration:
Parameter Definition
HTTP Port The network port number for accessing the DVR from a remote location.
The default port is 80
Server Port The port number for data. The default port is 6036
Static IP
IP Address The IP address of the DVR on your network
Subnet Mask The server's subnet mask
Gateway The gateway of the router
DNS Server The address of the Domain Name System (DNS) server
PPPoE
User Name User name of the broadband account
Password Password for broadband account
Substream Tab
The substream is the data that is sent to remote monitoring devices. Due to bandwidth
concerns, these data streams are generally smaller than those sent directly to the DVR itself.
These streams run in parallel with the main stream sent to the hard drive and they do not
affect each other.
Substream settings are configured in the
same manner as that used for the primary
stream settings in the Record Bitrate
tab in Section 4.3 Certain settings will be
grayed out and cannot be changed due to
throughput concerns. The definitions are
repeated for your convenience:
Parameter Options What it Means
D1 = Full TV resolution, CIF = 1/2 D1. D1 takes more
Resolution D1, CIF
room on the hard drive than CIF
Frames per second. More frames makes for smoother
FPS 1-30
video but takes up more room on the hard drive.
Variable Bit Rate versus Constant Bit Rate. VBR provides
Encode VBR, CBR better image quality for video with motion in it, but at the
expense of a larger file size.
Only available when VBR is selected. The higher the
Lowest
Quality quality, the more drive space required. CBR's default
– Highest
setting is for higher quality.
This sets the maximum bitrate that each camera will
Max Bitrate 256-2084kbps
record at with VBR encoding selected.
56
PICTURE 4-24
Email Tab
This tab allows you to set how your DVR will send out e-mail alerts. You will be able to send
e-mail alerts to three addresses.
NOTE! Depending upon your settings, the system can generate a lot of e-mail
alerts. For that reason, we recommend setting up a dedicated e-mail address
specifically for the system to send alert notices. If you do not have your own
e-mail system (such as a corporate mail server) you should consider using a
free e-mail provider. However, because many free e-mail services allow only
a limited amount of e-mail traffic we specifically recommend using Google's
Gmail service with its higher limit. Similarly, you will want the alert e-mails to go to a different
account than the one sending them. This will ease your management of these alerts and help
keep your mail account from overflowing.
If you do not have your own e-mail system, please set up a free account which the DVR can
use to send out alerts before proceeding.
For the example below, we will use Gmail. The settings can be found under Options when
logged into your Gmail account.
Clicking on any of the fields will bring up the virtual keyboard allowing you to enter the data.
The virtual keyboard is capable of handling upper and lower case letters as well as numbers
and symbols. Click the ENTER button to enter your input or ESC to exit the field without
applying any changes.
SMTP Server: smtp.gmail.com
Port: 465 (standard port for Gmail - others
may vary)
SSL Check: You will need to select this for
Gmail. Other ISPs may vary.
Send Address: Enter your new address. This
will appear on alert e-mails sent from
the DVR
Password: Enter the password you created
for this account. Remember, it will be
case-sensitive.
Receive Addresses: You may set up to three
e-mail addresses to receive alerts. It
is strongly advised that you do not
use the same address that the DVR is
using to send alerts.
Advanced
Attaching Image Amount: The alert e-mails can include up to three images
Snap Time Interval: The interval of the images can range from every second to every five
seconds.
PICTURE 4-25
57