Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Fisher-Price R4747
Summary of Contents for Fisher-Price R4747
- Page 1 R4747 www.fisher-price.com www.fisher-price.com...
-
Page 2: Consumer Information
Consumer Information • Keep mobile out of baby’s reach. • Remove mobile portion of product from crib or playpen when baby begins to push up on hands and knees. • This product may not attach to all crib designs. Do not add additional strings or straps to attach to crib or playpen. - Page 3 Assembled Parts Mobile Base Crib Connector Note: All of the screws used to assemble this toy are attached to the product. Follow these instructions carefully to fully secure the screws. Tighten and loosen all screws with a Phillips screwdriver. Do not over-tighten.
-
Page 4: Battery Installation
• Locate the battery compartment on the back of the base. • Loosen the screws in the battery compartment door and lift to remove it. • Insert three "C" (LR14) alkaline batteries. Hint: We recommend using alkaline batteries for longer battery life. •... -
Page 5: Battery Safety Information
Battery Safety Information In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage: • Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium). -
Page 6: Consumer Assistance
(2) this device must accept any interference received, including interference that may cause undesired operation. Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. ©2009 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. - Page 7 Base • • Fit the crib connector to the base, as shown. IMPORTANT! Make sure the straps are over the top of the crib connector. • Tighten both screws in the crib connector. SLIDE SLIDE • First press the button next to the socket and then slide the socket door open •...
- Page 8 Assembly Retainer Mobile Socket • Fit the mobile socket onto the retainer on the end of the arm. • Tighten both screws in the mobile to secure it to the arm.
-
Page 9: Crib Attachment
• Position the base so that the decorated side faces inside the crib. • Fit the base onto the crib top rail, as shown. • Make sure the top strap is hanging over the crib top rail. Position the bottom strap through the crib rails. - Page 10 • Tie the base strings to a crib spindle. Note: It is better to tie the strings in a knot than a bow, since a bow may be easily untied. • If the distance between the base and the mattress is less than 7 inches (18 cm), lower the crib mattress.
- Page 11 Gentle Motion, Soothing Sounds & Classical Music Song Select Button Song Select Button Press for music. Press the button again to change the song. Power/Volume Switch Power/Volume Switch Slide the switch to ON with low volume or ON with high volume .
- Page 12 Convert to a Music Box Remove the mobile portion and use as a music box! • Loosen both screws in the arm near the base. • Lift and remove the arm from the base. • Close the small door on top of the base. Store the mobile in a safe place for future use.