Warnings - HP nld Manual

noft Diagnostic Messages

Warnings

Warnings do not stop noft; therefore, the information under Recovery is merely a
correction you can make to eliminate the problem that causes each warning.
*** WARNING *** [2000]:
End of offset outside of procedure, dumping to end of
procedure.
Cause. The specified range of addresses or offsets goes outside the scope of the
procedure.
Recovery. Remove the scoping of the procedure with SET SCOPEPROC * (see
on page 5-42). Limit the range within the procedure.
*** WARNING *** [2001]:
No object file open. No dumping currently possible.
Cause. Stated in message.
Recovery. Use
command.
*** WARNING *** [2002]:
Not a Tandem COFF file: filename.
Cause. The specified file was expected to be a COFF file, but it is not.
Recovery. Specify a COFF file.
*** WARNING *** [2003]:
Selected file has greater version number than noft.
Cause. The specified object file was created with later versions of native mode
compilers and linker than noft supports; therefore, noft might not understand the
object file format.
Recovery. Use a newer version of noft.
FILE or F on page 5-15 to open an object file and then reissue the
nld and noft Manual—520384-003
11 -18
Warnings
SET