HP eld Manual page 45

eld Input and Output
described below (after, in effect, deleting the old entry for the DLL from the registry),
and updates the registry accordingly.
The -grow_limit option may only be specified if -update_registry is used. If
-grow_limit is not specified then the linker determines the reserved size of the DLL
from the following options, which are only allowed when -update_registry is used
and -grow_limit is not used:
•
-grow_text_amount the absolute amount by which the text may grow
•
-grow_data_amount the absolute amount by which the data may grow
•
-grow_percent the percentage amount by which the text or data may grow
The defaults for -grow_text_amount and -grow_data_amount are 0. The
default for -grow_percent is 10. A size is calculated for each of text and data by
first adding the corresponding "amount" option to the size of that segment (before
rounding), or adding the percentage specified by the "percent" option to the size of that
segment (before rounding), and taking the maximum of these two values. The resulting
size for each segment is then rounded up to a multiple of 64KB (or, 128KB if the linker
is building an implicit DLL), and the sum of these two sizes is the reserved size of the
DLL.
When the linker is choosing a new place for a DLL, because it wasn't specified in the
registry before or didn't fit where the the registry previously specified, and the
-grow_limit option has been given, the reserved size that the linker gives to the
new entry in the registry is the value specified in the -grow_limit option, rounded
up to a multiple of 64KB (or, 128KB if the linker is building an implicit DLL). In this case
reports an error if the sum of the sizes of all the segments of the DLL (including
eld
rounding) is larger then the value specified in this option (rounded up to a multiple of
64KB or 128KB, depending on whether it is an implicit DLL).
If the DLL name was not already listed in the file, or didn't fit in the place previously
listed for it, then the linker chooses the address for the DLL by looking for blocks of
space that are at least as large as the reserved size for this DLL, that lie within the
range of addresses that the registry allows for DLLs, and that don't overlap the space
reserved for any other DLLs in the registry.
large enough. The linker chooses such a block that is closest to the starting address
for the registry. Thus, the linker searches upward from the lower bound of possible
addresses, or downward from the upper bound, depending on how the bounds were
specified for this registry. The registry is updated to tell the address and reserved size
of the new DLL.
If the user wishes to specify an address for a new DLL in the registry, rather than
letting the linker choose the address, the registry file can be edited by hand. It is
necessary to specify both the starting address of the DLL and its reserved size, as
multiples of 64KB. Or, if this is a registry that is being used for implicit DLLs, then they
should be multiples of 128KB. It is also possible to change these values for a DLL
already listed in the registry. It is permissible to edit a registry so that some DLLs have
overlapping address ranges. When the linker picks an address on its own it requires
that this DLL not overlap any other ones in the registry, but the linker doesn't check
reports an error if there is no block
eld
eld Manual—527255-009
2-11
Using a DLL Registry