HP e3000 MPE/iX Manual page 53

18 MESSAGE: Ldev not mounted as MASTER or MEMBER — (HAFOERR
18)
CAUSE: The volume associated with specified Ldev has not mounted as a
master or member.
ACTION: Check the state of the volume set using "DSTAT". The volume must
be mounted as a master or member. If not, use the "VOLUTIL" utility to change
to the appropriate state or remove Ldev from HAFO configuration.
19 MESSAGE: Ldev does not exist — (HAFOERR 19)
CAUSE: Ldev input was not valid.
ACTION: Input correct Ldev with command.
20 MESSAGE: Gonext failed — Ldev <Ldev #> has not Failed over —
(HAFOERR 20)
CAUSE: GONEXT was attempted on an Ldev that has not failed over or
GONEXT was attempted on a primary path that is broken.
ACTION: Run HASTAT utility and check status of Ldev's paths.
21 MESSAGE: No devices to list — (HAFOERR 21)
CAUSE: No devices have been configured for HAFO.
ACTION: None.
22 MESSAGE: Device not configured — (HAFOERR 22)
CAUSE: The device specified to be displayed has not been configured for
HAFO.
ACTION: None.
23 MESSAGE: Ldev does not exist in HAFO configuration file — (HAFOERR
23)
CAUSE: HAFOCONF file record associated with specified Ldev was not found.
ACTION: None.
24 MESSAGE: Ldev already configured for HAFO — (HAFOERR 24)
CAUSE: Ldev specified has previously been configured for HAFO.
ACTION: None.
Appendix-B
53