Cutting Equipment; Checking, Maintaining And Servicing The Machine's Safety Equipment - RedMax BC280 Owner's/Operator's Manual

SAFETY INSTRUCTIONS
Muffler
The muffler is designed to reduce the noise
level and to direct the exhaust gases away
from the operator.
CAUTION! Muffler is fitted with a catalytic
converter designed to reduce exhaust gas
emissions.
For mufflers, it is very important that you fol-
low the instructions on checking, maintain-
ing, and servicing your machine.
See Checking, maintaining and servicing the
machine's safety equipment section.
CAUTION:
Mufflers fitted with cata-
lytic converters get very hot during use
and remain so for some time after stop-
ping. This also applies at idle speed. Con-
tact can result in burns to the skin. Re-
member the risk of fire!
WARNING:
The inside of the
muffler contain chemicals that may
be carcinogenic. Avoid contact
with these elements in the event of
a damaged muffler.
WARNING:
Engine exhaust
fumes contain carbon monoxide,
which can cause carbon monoxide
poisoning. DO NOT start or run the
machine indoors, or anywhere that
is poorly ventilated. The exhaust
fumes from the engine are hot and
may contain sparks which can start
a fire. Never start the machine in-
doors or near combustible material!

Cutting equipment

A trimmer head is intended for trimming
grass.
115391527 Rev. 4 5/15/12
Checking, maintaining and
servicing the machine's
safety equipment
IMPORTANT!
All servicing and repair work on the
machine requires special training. This is
especially true of the machine's safety
equipment. If your machine fails any of the
checks described below you must contact
your servicing dealer. When you buy any
of our products we guarantee the availabil-
ity of professional repairs and service. If
the retailer who sells your machine is not a
servicing dealer, ask him for the address of
your nearest servicing dealer.
Stop switch
S Start the engine and make sure the engine
stops when you push and hold the stop
switch.
Cutting attachment guard
S Ensure that the guard is undamaged and
is not cracked.
S Replace the guard if it has been exposed
to impact or is cracked.
S Always use the recommended guard for
the cutting attachment you are using. See
section on "Technical data".
English--- 6