Signal Mode Column (Recommended) - Sanyo LCE-24C100F(K) Instruction Manual

SIGNAL MODE COLUMN (Recommended)

This LCD TV can correspond to the signals below. After connecting with the computer, LCD TV can automatically
recognize the signal from the connected PC( computer)/ HDMI.
PC SIGNAL MODE COLUMN (recommended)
Note:
● In case LCD TV can not display properly due to the connecting cable or the graphic hardware, please make
adjustments about phase, clock and so on.
● In principle, LCD TV can not display the signal mode which not described in the above column. But sometimes
it can display a signal very similar with one of the signal described.
● If you want to change the definition and colour of PC, please select one from the column.
● It is not the trouble of LCD TV if interference appears on the picture while switching the signal mode.
● It is different from CRT Monitor that it is no blink of the picture when the V-Freq. of the signal s 60Hz. It is
recommended to select 60Hz V-Freq. of your computer to display better pictures.
● The Dot Clock of the computer's signal must be less than 100 MHz.
● Specifications are subject to change without notice.
In case of the following things, some messages will display on the screen.
● When the input signal from PC is out of the display range, "OUT OF RANGE" will display.
When input signal is digital from DVD terminal, refer to the chart below.
When input signal is digital from HDMI terminal, refer to the chart below.
NO. Resolution
EIA1920×1080i@60
EIA1920×1080p@60
EIA1920×1080i@50
EIA1920×1080p@50
EIA1280×720p@60
EIA1280×720p@50
EIA720x480p(w)@60
EIA720x576p(w)@50
Audio Freq. Format :
TM
HDMI (V.1.3 with Deep Color
Frame
Frequency
33.750 60.00H
Z
67.500 60.00H
Z
28.125 50.00H
Z
56.250 50.00H
Z
45.000 60.00H
Z
37.500 50.00H
Z
31.500 60.00H
Z
31.250 50.00H
Z
APPENDIX
19