Maintenance; Display Codes - Haier HW80-B1486 User Manual

21

DISPLAY CODES

DISPLAY CODES AND SPECIAL FUNCTIONS
CODES CAUSES
Err1 ¬ Door is not properly shut.
Err2 ¬ Drainage error, water not emptied within 6
minutes.
Err3 ¬ Temperature sensor not properly connected or
damaged.
Err4 ¬ Heater error (Appears at the end of a cycle).
Err5 ¬Water level not met in 8 minutes.
¬The height of the drain hose is below 80 cm.
¬ The drain hose is in water.
Err7 ¬ Motor error .
Err8 ¬ Water exceeds protective level.
¬ The signal of Water level sensor is wrong.
Er10
EuAr ¬ The PBC and the motor cant't communicate.
End ¬ End of wash cycle.
1:25 ¬The remaining time is 1 hour 25 minutes.
19:30 ¬Status information:Preset time for delayed operation.
UNb After the last rinsing cycle finishes,spinning fails completely due to unbalance of the laundry.
¬ Control panel lock function: Press the "Delay" and the "Start/Pause" buttons simultaneously for 3 seconds after starting a program.
It can no longer be changed by operating buttons or knobs. To unlock press the "Delay" and "Start/Pause" buttons again for 3
seconds.
¬ Power-off memory function: In case of abrupt power failure or the need to cut off the power during a program cycle, the present
settings will be saved and the preset operation will resume when the power is on again.
¬ To cancel a program
Press the "Start/Pause" button, then switch off the power and the program is automatically cancelled. Turn the program selector
again to choose another program.
Note: During the spin process, if too much foam is inspected, in order to protect the motor, the washing machine will eliminate the
foam automatically; the motor will stop and the drain pump will drain the water continuously for 90 seconds. If it happens more than
3 times, the motor will stop until the end of cycle without spinning.

MAINTENANCE

SOLUTIONS
_ Shut the door properly and then press the Start/Pause button.
_ Clean the filter and check the drain hose for blockage. If error
still exists, please contact the maintenance personnel.
_ Contact the maintenance personnel.
_ Contact the maintenance personnel.
_ M k a
If problem still exists, please contact the maintenance personnel.
_ Install drain hose within 80-100 cm of height.
_ Make sure the drain hose is not in water.
_ Contact the maintenance personnel.
_ Contact the maintenance personnel.
_ Contact the maintenance personnel.
_ Contact the maintenance personnel.
s e e r u a h t a t t s i p r u t d e n , n o d n a t a w p r e s s e r e r u n s i m r o . l a