Table of Contents
Advertisement
Unpacking:
1. Check crate for possible damage sustained during
transit. Carefully remove unit from crate and again
check for damage. Any damage to the appliance
must be reported to the carrier immediately.
2. The wires for retaining the burners and other
packing material must be removed from units. Any
protective material covering stainless steel parts
must also be removed.
3. All ranges are shipped from the factory with casters
fitted.
4. The splash back is packed separately.
STW286
Oven Interior Dimensions
Height
Width
13-12"
26-1/4"
(343mm)
(667mm)
Hot Top
BTU
kW
25,000
7.32
50,000
Model
STW286
SUFFIX DEFINITIONS
STW 286
Page 4
GENERAL INFORMATION
DIMENSIONS & SPECIFICATIONS
EXTERIOR DIMENSIONS
Model
Height
46-3/4" (1187mm)
NOTE: Height dimensions specified with casters fitted.
Entry Clearance
Depth
Crated
22"
43"
(559mm)
(1105mm)
Input Ratings
Griddle
Oven
BTU
kW
BTU
14.65
30.000
36" wide x 46.75" high range with convection over, 12" hot top and 24" griddle section
286 - 36" wide range with 12" solid hot hot section & 24" griddle
STW - Starfire Sentry range series
5. The type of gas and the supply pressure that the
equipment was set up for at the factory is noted on
the data plate and on the packaging. This type of
gas supply must be used.
6. Do not remove permanently affixed labels, warnings
or data plates from the appliance, for this may
invalidate the manufacturer's warranty.
Serial Plate Location:
All burner input ratings are shown on the name/rating
plate of each range which can be located as follows
behind the lower front kick panel, (located below oven
door). To access, remove two (2) fasteners securing the
panel shut.
Width
36" (914mm)
Installation Clearances
Uncrated
Sides
37-7/8"
7"
(648mm)
(178mm)
Total
kW
BTU
KW
8.79
105,000
30.76
Description
Depth
40-1/2 (1029mm)
Shipping
Manifold
Weight
Inlet Size
Rear
6"
584lbs.
3/4" NPT
(152mm)
(265kg)
Operating Pressure
Natural
"WC
mbar
"WC
4.5
11
10
P151 Rev. 1 (03/05)
Female
Propane
mbar
25
Advertisement
Table of Contents
