Installing Batteries In The Remote Control; Using A Remote Control; The Vcr / Dvd Recorder Switching - Sylvania DVR90VG Owner's Manual

Installing batteries in the remote
control
1
Install two "AA" size batteries (supplied), matching
their polarity to those indicated inside battery
compartment of the remote control.
1
2
2
3
Note:
Incorrect use of batteries can result in hazards such
as leakage and bursting. Please follow the instruction
below:
• Do not mix new and old batteries together.
3
• Do not use different kinds of batteries together.
Although they may look similar, different batteries
may have different voltages.
• Make sure that the plus and minus ends of
each battery match the indications in the battery
compartment.
• Remove batteries from equipment that is not going
to be used for a month or more.
• When disposing used batteries, please comply
with governmental regulations or public rules for
environmental protection that apply in your country
or area.
• Do not recharge, short-circuit, heat, burn or
disassemble batteries.

The VCR / DVD recorder switching

Because this product is a combination of a VCR and a DVD recorder, you must select first which component
you wish to operate with [OUTPUT SELECT].
VCR MODE
Press [VCR ] on the remote control.
(Verify that the VCR indicator is lit.)
DVD MODE
Press [DVD ] on the remote control.
(Verify that the DVD indicator is lit.)
Note:
• Pressing only [OUTPUT SELECT] on the front
panel DOES NOT switch the mode of the remote
control. You MUST select the correct mode on
the remote control.
• You cannot switch to another mode (DVD or
VCR) during in the timer-standby mode.
• Pressing [REC/OTR] (DVD) or [REC/OTR] (VCR)
on the remote control switches immediately its
respective mode so that you can start recording
directly on the appropriate media.
10
EN
Before you start
1
Functional overview (cont'd)
2
3

Using a remote control

Keep in mind the following when using the remote
control:
• Make sure that there is no obstacle between the
remote control and the remote sensor of the unit.
• Remote operation may become unreliable if
strong sunlight or fluorescent light is on the
remote sensor of the unit.
• Remote control for different devices can interfere
with each other. Avoid using remote control for
other equipment located close to the unit.
• Replace the batteries when you notice a fall-off of
the operating range of the remote control.
• The maximum operable ranges from the unit are
as follows.
- Line of sight: approx. 3 feet (7m)
- Either side of the center:
approx. 16 feet (5m) within 30°
- Above: approx. 16 feet (5m) within 15°
- Below: approx. 10 feet (3m) within 30°
Within about
23feet (7m)
30°
30°
Remote
control
OUTPUT SELECT button
OPEN/CLOSE
A
POWER REW F.FWD STOP/EJECT PLAY DUBBING
E D C A B
OUTPUT SELECT
VCR CHANNEL
L K
VCR s
RECORD
OUTPUT SELECT
VCR s B DVD
POW
ER
REW
F.FW
E D STO
D P/EJ
C A ECT PLA
Y
B
VCR VCR
OPE
N/CL OSE
REC REC A
ORD ORD
REPE
AT
B
TRK. DUB
DVD BING
L CHA
NNE L K
STO
P
OUT C PLA Y
VCR PUT SEL
s ECT B
B
DVD
DVD
REC ORD
S-V IDEO
VIDE O
L-A UDIO
-R
POWER
T-SET TIMER PROG.
.@/:
ABC
1 2
GHI JKL
STOP PLAY
4 5
C B
DVD S-VIDEO VIDEO L-AUDIO-R PQRS TUV
B DVD
7 8
RECORD
DISPLAY SPACE
0
TOP MENU MENU/LIST
VCR button
REC/OTR VCR
DVD button
REC SPEED
x1.3/0.8 SKIP
SLOW CM SKIP
DVD indicator
DUBBING ZOOM
VCR indicator
OPEN/CLOSE
DEF
3
MNO CH
6
WXYZ VIDEO/TV
9
CLEAR SETUP
RETURN ENTER
DVD REC/OTR
PLAY
PAUSE SKIP
SEARCH
STOP
AUDIO