Installing Batteries In The Remote Control; Using A Remote Control; The Vcr/Dvd Recorder Switching - Sylvania DVR90VF Owner's Manual

Installing batteries in the remote control

Install two "AA" size batteries (supplied), matching
their polarity to those indicated inside battery com-
partment of the remote control.
1
2
Note:
Incorrect use of batteries can result in hazards such
as leakage and bursting. Please follow the instruction
below:
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
Although they may look similar, different batteries
may have different voltages.
• Make sure that the plus and minus ends of each
battery match the indications in the battery com-
partment.
• Remove batteries from equipment that is not going
to be used for a month or more.
• When disposing used batteries, please comply with
governmental regulations or public rules for envi-
ronmental protection that apply in your country
or area.
• Do not recharge, short-circuit, heat, burn or disas-
semble batteries.

The VCR/DVD recorder Switching

Because this product is a combination of a VCR and a DVD recorder, you must select first which com-
ponent you wish to operate with [OUTPUT SELECT].
VCR MODE
Hit [VCR] on the remote control.
(Verify that the VCR indicator is lit.)
DVD MODE
Hit [DVD] on the remote control.
(Verify that the DVD indicator is lit.)
Note
• Hitting only [OUTPUT SELECT] on the
front panel DOES NOT switch the mode of the
remote control.You MUST select the correct
mode on the remote control.
• You cannot switch to another mode (DVD or
VCR) during in the timer-standby mode.
• Pressing [REC/OTR] (DVD) or [REC/OTR]
(VCR) on the remote control switches immedi-
ately its respective mode so that you can start
recording directly on the appropriate media.
10
Before you start
Functional overview (cont'd)
3

Using a remote control

Keep in mind the following when using the remote
control:
• Make sure that there is no obstacle between the
remote control and the remote sensor of the
unit.
• Remote operation may become unreliable if
strong sunlight or fluorescent light is on the
remote sensor of the unit.
• Remote control for different devices can inter-
fere with each other. Avoid using remote control
for other equipment located close to the unit.
• Replace the batteries when you notice a fall-off
of the operating range of the remote control.
• The maximum operable ranges from the unit are
as follows.
- Beeline: approx. 23 feet (7m)
- Either side of the center:
approx. 16 feet (5m) within 30°
- Above: approx. 16 feet (5m) within 15°
- Below: approx. 10 feet (3m) within 30°
Within about
23feet (7m)
30˚
30˚
Remote
control
OUTPUT SELECT button
OPEN/CLOSE
A
POWER REW F.FWD STOP/EJECT PLAY DUBBING
E D C A B
OUTPUT SELECT
VCR L CHANNEL K
REPEAT TRK.
DVD VCR s
B
RECORD
OUTPUT SELECT
VCR s B DVD
POW
ER
REW
E F.FW
D STO
D P/EJ ECT
C A PLA
Y
B
VCR VCR
OPE N/CL
REC REC OSE
ORD ORD A
REPE
AT
B
TRK. DUB
DVD BING
L CHA
NNE L
K
STO P
OUT C PLA
VCR PUT SEL Y
s ECT B
B
DVD
DVD
REC
ORD S-V
IDEO
VIDE
O
L -
AUD IO -
R
POWER
T-SET TIMER PROG.
.@/:
ABC DEF
1 2
GHI JKL MNO
STOP PLAY
C B
4 5
S-VIDEO VIDEO L - AUDIO - R
DVD
PQRS TUV WXYZ
B DVD
RECORD
7 8
DISPLAY SPACE CLEAR
0
TOP MENU MENU/LIST RETURN
VCR button
REC/OTR DVD
VCR
DVD button
REC SPEED PLAY
REC MONITOR SKIP PAUSE
SLOW CM SKIP STOP
DVD indicator
DUBBING ZOOM AUDIO
VCR indicator
OPEN/CLOSE
3
CH
6
VIDEO/TV
9
SETUP
ENTER
REC/OTR
SKIP
SEARCH