Lan Cable Connection (For Iscsi) - Fujitsu Eternus DX60 User Manual

Chapter 6 Cable Connection

6.4 LAN Cable Connection (For iSCSI)

3
3-1
3-2
6.4 LAN Cable Connection (For iSCSI)
Connect the ETERNUS DX60/DX80 and the server or switching hub with LAN cables (enhanced
Cat-5 type).
User must prepare their own LAN cables.
IMPORTANT
CAUTION
•
Connect the other end of the Fibre Channel cable to the server or Fibre Channel
switch.
Remove the covers from the Fibre Channel cable connectors.
Connect the Fibre Channel cable to the Fibre Channel adapter in the server or Fibre
Channel switch.
• Use a separate LAN for the iSCSI connection.
• The iSCSI interface operates in 1000Base-T full-duplex mode.
• When connecting the ETERNUS DX60/DX80 and the server via a
switching hub, the switching hub must be able to support 1Gbit/s con-
nection.
Do
CAUTION
• Be sure to wear a wrist strap or discharge static electricity by
touching the metal frame of the ETERNUS DX60/DX80 before
starting each operation, as failure to discharge static electricity may
cause device failure.
• When connecting external (signal, power, etc.) cables, avoid pulling
them as it may cause device damage.
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
Do
When connecting the Fibre Channel cables, position them so
that they will not obstruct replacement of the power supply
unit or controllers by the maintenance engineer.
114
End of procedure
P3AM-3042-08ENZ0