Swing Operation; Manual Auto Operation - Fujitsu ASU9R1 Operating Manual

SWING OPERATION

Begin air conditioner operation before performing this procedure.
To Select SWING Operation
Press the SWING LOUVER button (Fig.6 £ ).
The SWING Indicator Lamp (orange) (Fig. 3 7) will light.
In this mode, the Air Flow Direction Louvers will swing automatically to direct the
airflow both up and down.
To Stop SWING Operation
Press the SWING LOUVER button (Fig.6 £ ) once again.
The SWING Indicator Lamp (orange) (Fig. 3 7) will go out.
Airflow direction will return to the setting before swing was begun.
About Swing Operation
÷ The SWING range is as follows:
Cooling/
1 3 ,
Dry mode
Heating
4 7
mode
÷ The SWING operation may stop temporarily when the
air conditioner's fan is not operating or when operating
at very low speeds.
÷ The airflow direction can not be adjusted during SWING
operation even when the AIR FLOW DIRECTION button
is pressed.

MANUAL AUTO OPERATION

Use the MANUAL AUTO operation in the event the Remote Control Unit is lost or otherwise unavailable.
How To Use the Main Unit Controls
Press the MANUAL AUTO button (Fig. 2 2) on the main unit
control panel.
To stop operation, press the MANUAL AUTO button once again.
(Controls are located inside the Intake Grille)
7)
NOTE
(4
1
2
5
4
NOTE
During the cooling mode operation, the air swings
between 4 and 7 by pressing the SWING LOUVER
button after selecting the air direction 6 (downward)
by pressing the AIR FLOW DIRECTION button.
Use this operation when you want to cool yourself for
a while after taking a bath or shower, or after coming
back home in summer months.
But, for prevention of condensation on the louver, the
swing of the air direction 4Ô7 is automatically
released after 30 minutes and turned to the swing of
the air direction 1Ô3.
¶ When the air conditioner is operated
with the controls on the Main Unit, it
will operate under the same mode as
the AUTO mode selected on the Re-
mote Control Unit (see page 8).
¶ The fan speed selected will be "AUTO"
and the thermostat setting will be stan-
dard.
3
6 7
En-12