Power Wheels JEEP WRANGLER 78490 Owner's Manual page 13

12
Hood Latch
Hole
• Insert a hood latch into one of the holes in the vehicle
body, near the hood area.
• Twist the base of the hood latch
the vehicle body.
• Repeat this procedure on the other side of the hood
area to attach the other hood latch to the vehicle body.
13
Hood
Slot
• Position the hood over the front of the vehicle body
as shown.
• Insert the tabs on the hood into the slots in the
vehicle body.
• Close the hood.
Assembly
Hood
Latch
Hole
1 / turn to secure it in
4
Tabs
Slot
14
#8 x 1" Screws
• With the flat sides of the windshield brackets facing the
dash, fit the screw pegs on the windshield brackets into
the holes in the top surface of the dash.
• Insert two #8 x 1" screws into each windshield bracket.
• Tighten the screws with a Phillips screwdriver.
• Do not over-tighten.
15
Windshield
Slots
#10 x 3" Screw
Bracket
• Fit the slots on the back side of the windshield onto the
windshield brackets.
• Insert a #10 x 3" screw through the hole in one side of
the windshield and through the holes in the hinge bracket.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
• Insert a #10 x 3" screw through the hole on the other side
of the windshield.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
13
#8 x 1" Screws
Windshield
Brackets
Slots
#10 x 3" Screw