Access Point Configuration - Cisco AS-2000 Configuration Manual

Airespace Wireless Enterprise Platform—AireOS AS-2000 Switch Controller with AP10-xx Access Point

Access Point Configuration

Parameter
802.11b Network Status
Data rates:
Beacon period (Kusec)
Antenna
Enable short preamble
* For optimum capacity, set Mandatory if handsets are all operating at 11 Mb/s and the SpectraLink 8000
SVP Server is installed.
PN: 1725-36047-001_G.doc
1. Connect to the Airespace switch or controller via Netscape or
Internet Explorer by navigating to the URL http://<IP_Addr>
(where <IP_Addr> is the IP address of the switch or controller).
2. The following table shows additional settings for the 802.11b
Network configuration. Navigate to this page by clicking the
tab at the top of the screen and
Wireless
navigation pane.
Setting
Checked
1.0 Mandatory
2.0 Mandatory
5.5 Mandatory/Supported *
11 Mandatory/Supported *
100
Diversity
Not Checked
3. Click the button to save the changes.
Apply
4. Click the button, to the right of the
Auto-RF
5. The following table shows additional parameters for the
configuration. Scroll to the bottom of the page to enter these
parameters.
Parameter
Noise measurement
Load measurement
Signal measurement
Coverage measurement
802.11b Network
Criticality
Required
Required
Required
Required
Required
Required
Required
Required
button.
Apply
Setting Criticality
3600 Required
3600 Required
3600 Required
3600 Required
in the
Auto-RF
5