Using Your Control(S); Dual Operation Settings; Step-By-Step - Sunbeam warming User Manual

Using your Remote Control(s):
1 To turn the warming pillow top mattress pad ON, simply press the
"On/Off" button. The backlit display light will illuminate and begin
to warm at the comfort setting last used.
CAUTION: ALWAYS turn the warming pillow top mattress pad
OFF when not in use.
2 To turn the warming pillow top mattress pad OFF simply press the
"On/Off".

Step-by-step

1 Lay the warming pillow top mattress pad on the bed with the label at the foot of the bed (pillow top
surface facing up, module facing down).
2 Make sure the base unit cord is connected into the module until
the plastic hinges click into place.
CAUTION: Cord must be COMPLETELY CONNECTED. A risk of fire
could result from a loose connection.
3 Run the base unit cord on the floor under the bed. Do not
sandwich cord between the mattress and box spring. Avoid any
tangling or pinching.
4 Place the base unit on the floor under the bed.
5 Control placement:
• Dual Control – from the lying position, place the right control on the right side of the bed.
Place the left control on left side of bed.
• Single Control – Place the remote control where it is convenient for you.
6 Plug power cord into a 110-120 volt wall outlet.
*Please see page 6 if you have more than one Sunbeam Remote Control Warming Product.

Dual operation settings:

While lying in bed, each person can have complete control over his/her comfort level for ultimate personalized warmth.
From the lying position:
The "left"
control operates
the left side.
Either "right" or "left" control can be set to operate the entire pillow top mattress pad.
• Locate the dual control setting switch (on back of each control, above battery panel).
• Set switch to preferred operating setting – both sides or one side only.
2
The "right"
control operates
the right side.
CAUTION: Do not plug main
power cord into the wall outlet
until you have completely set
up your warming product per
the instructions.
• Disconnect power cord from
wall before detaching
control from warming
product.
• Always make sure cords are NOT trapped or pinched
between bed slats, mattress, springs, against wall, foot
board or bed frame, or between furniture, walls
or chairs.
CAUTION: Do not attempt to force the plug. This appliance
has a polarized plug (one blade is wider than the other). To
reduce the risk of electrical shock, this plug is intended to fit
only one way into an outlet. If the plug does not fit in the
outlet, reverse the plug. If it still does not fit, contact a
qualified electrician.
Dual
Control
Setting
Switch
IMPORTANT
5