Multiple Remote Control Warming Products; Changing The Remote Settings - Sunbeam warming User Manual

Multiple Remote Control Warming Products

If you own two or more Sunbeam remote controlled warming products (in your home), interference is likely to occur. To avoid interference
between multiple remote controlled warming products, you must change the address of both the remote control and the base unit of the
second warming product.
To change the address of your SECOND warming product:
Remote Control:
1 Open the battery door on the remote control(s). You will see a small square silver colored switch under the battery door latch.
2 You will see two small switches labeled "1" and "2". To change the address of the remote, carefully move one of the switches to the up
position with a small screwdriver.
standard address
3 alternate address options
Once the address has changed on the controller, you must set the base unit switch to match.
Remote controller
WARNING: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate equipment.
6