Williams 3144030 Owner's Manual page 12

Trim
TRIM STRIP KIT 4701
When desired, optional Trim Strip Kit may be used to cover
the crack between furnace and wall. See Fig. 13.
Place strips tight against furnace with other edge against
wall surface and fasten to wall with escutcheon pins pro-
vided. Cut off trim strips to fit each furnace as required.
FURNACE TRIM
TRIM
MOULOING
(OPTIONAL)
NOTE
Quarter-round wood molding may be used for trim if
desired, which may be painted to match the wall,
TRIM COVER (SURFACE MOUNT)
1. To conceal the furnace wiring, set top trim cover inside
the flanges of furnace top.
2. Fasten to the furnace cabinet with (2) short screws
provided.
TRIM COVER (RECESSED MOUNT)
1. Trim off the back edges of the top trim cover (a little
at a time) until it fits between the front cabinet flange
and the wall.
2. When trimmed to your satisfaction, set in place on fur-
nace top and drill (2) #33 holes through top trim cover
and furnace side flanges.
3. Fasten cover to furnace with (2) short screws provided.
m12--