Whirlpool Cabrio WTW7800XL0 Use And Care Manual page 18

TROUBLESHOOTING
f
oL (overloaded)
appears in display
uL (unbalanced load)
appears in display
LF (too long to fill)
appears in display
Ld (too long to drain
water ) appears in
display
HC (Hot and Cold
hoses reversed)
appears in display
Sd (Excess suds)
appears in display
First try the solutions suggested here or visit our website at www.whirlpool.com/help
for assistance and to possibly avoid a service call.
Load too large.
Load not balanced. The washer is
running a load-balance correction
routine.
Washer taking too long to fill.
Drain extends more than
4.5" (114 mm)into standpipe.
Washer taking too long to drain
water. Drain extends more than
4.5" (114 mm)into standpipe.
Hot and cold inlet hoses have been
installed incorrectly.
Excessive suds in washer. Washer is
running a suds reduction routine.
Solution
If the washer is overloaded, it will drain any water and detergent
in the washer. Remove several items and add HE detergent
Close lid and press START/PAUSE.
Allow the machine to continue. If the dial is flashing and the
machine has stopped, redistribute the load, close the lid, and
press START/PAUSE.
Check plumbing for correct drain hose installation. Use drain
hose form and attach securely to drainpipe or tub. Do not tape
over drain opening. See "Installation Instructions".
Check plumbing for correct drain hose installation. Use drain
hose form and attach securely to drainpipe or tub. Do not tape
over drain opening.
Lower drain hose if the end is higher than 96" (2.4 m) above
the floor. Remove any clogs from drain hose. See "Installation
Instructions".
This code will appear at the end of the wash cycle to indicate
that cold water hose is connected to the hot water inlet and hot
water hose is connected to the cold water inlet.
Allow the machine to continue. Use only HE detergent.
Always measure detergent, and base detergent quantity on
load size. Follow detergent manufacturer's instructions. If the
dial is flashing, reselect your desired cycle using a cold wash
temperature, and press START/PAUSE. Do not add detergent.
dL (Lid cannot lock) An item in the load may be keeping Make sure that the washer is not overloaded, and make sure no
appears in display the lid from locking, items are above the top of the stainless steel basket.
lid (Lid opened) Washer lid left open. Close the lid to clear the display. If the lid is left open for more
appears in display than 10 minutes, the cycle will reset and water in the washer
will drain.
dU (Lid cannot unlock) Objects on washer lid keep it from Remove objects, such as a basket of laundry, from the top of
appears in display unlocking, the washer.
F## code (F-type System error code. Press START/PAUSE once to clear the code. Then press
error code) appears START/PAUSE again to restart washer. If code appears again,
_ display call for service.
J
18