Whirlpool Cabrio WTW7800XL0 Use And Care Manual page 15

Washer not draining/
spinning, loads are
still wet
Incorrect or wrong
wash or rinse
temperatures
Load not rinsed
Empty pockets and use garment bags
for small items.
Using cycles with a lower spin speed.
The washer may be overloaded.
Check plumbing for correct drain
hose installation. Drain hose extends
into standpipe farther than 4.5"
(114 mm).
Not using HE detergent or using too
much HE detergent.
Check for proper water supply.
Energy saving controlled
wash temperatures.
Check for proper water supply.
Not using HE detergent or using too
much HE detergent.
Washer not loaded as recommended.
Small items may have been caught in pump or between basket
and tub, which can slow draining.
Cycles with lower spin speeds remove less water than cycles
with high spin speeds. Use the recommended cycle/speed spin
for your garment.
Overloading or unbalanced loads will not allow the washer to
spin correctly, leaving the load wetter than normal. See "Using
Your Washer" for loading recommendations.
Check drain hose for proper installation. Use drain hose form
and securely attach to drainpipe or tub. Do not tape over drain
opening.
Lower drain hose if the end is higher than 96" (2.4 m) above the
floor. Remove any clogs from drain hose.
Suds from regular detergent or using too much detergent can
slow or stop draining or spinning. Use only HE detergent.
Always measure and follow detergent directions for your
load. To remove extra suds, Select RINSE & SPIN. Do not
add detergent.
Are ho_ and cold inlet_loses reversed?
Both hoses must be attached to both washer and faucet, and
have both hot and cold water flowing to inlet valve.
Check that inlet valve screens are not clogged.
Remove any kinks in hoses.
Energy Star washers use cooler wash and rinse water
temperatures than your previous washer. This includes
cooler hot and warm washes.
Are hot and cold inlet hoses reversed?
Both hoses must be attached and have water flowing to the
inlet valve.
Both hot and cold water faucets must be on.
Inlet valve screens on washer maybe clogged.
Remove any kinks in the inlet hose.
The suds from regular detergent can cause the washer
to operate incorrectly.
Use only HE detergent. Be sure to measure correctly.
Always measure detergent and follow detergent directions
based on toad size and soil level.
The washer is less efficient at rinsing when overloaded.
Load garments in loose heaps evenly around the basket wall.
Do not load above maximum recommended load height. The
washer will not rinse well if overloaded. Load with dry items only.
Use cycle designed for the fabrics being washed.
Add only 1 or 2 garments after washer has started.
Fabric softener option not selected. When using fabric softener, be sure the Fabric Softener option
k,, is selected. .J
15