Table of Contents
Advertisement
SECTION 2: ASSEMBLING THETILLER
NOTE:
All references to the RIGHT or LEFT side of the
tiller are observed from operator's position.
ToolsNeeded for Assembly
9/16" Wrench
(Handle Mount Bracket)
7/16" Wrench or Nutdriver (Control Box)
Two 1/2" Wrenches
(Threaded Cable Adjuster)
Phillips Screwdriver
(Control Box)
Attaching theHandle
NOTE:
Before beginning assembly, unfasten the cables
and lay them across the back of the tiller. Having an
assistant will ease completion of the following steps.
1.
Remove the lower handle hardware (two hex screws,
two lock washers, one carriage screw & one handle
crank) from the titler's frame.
2.
Position the handle mount bracket over the tiller
frame.
3.
Align the handle mount bracket's rear holes (either
upper or lower, depending on the operator's height)
with the holes in the tiller frame. Insert the carriage
bolt through the holes from right to left and secure it
with the handle crank.
4.
Align the handle mount bracket's front holes with the
holes in the tiller frame. Using a 9/16" wrench, secure
the handle mount bracket to the tiller frame with the
hex screws and lock washers removed earlier.
Advertisement
Table of Contents
