Table of Contents
Advertisement
and functions
Batteries
into the Remote
Control:
Open the battery compartment
cover in the direction of the ar-
row.
Install two"AAA" batteries, pay-
ing attention to the polarity dia-
gram in the battery
compart-
ment.
Replace the compartment cover.
=_
C
÷
Caution:
Never throw batteries into a fire.
Note:
Be sure to use AAA size batteries.
Dispose of batteries in a designated disposal area.
,, Batteries should always be disposed of with the environment in mind. Always dispose of batteries in
accordance with applicable laws and regulations.
,, If the remote control does not operate correctly, or if the operating range becomes reduced, replace batteries
with new ones.
When necessary to replace batteries in the remote control, always replace both batteries with new ones.
Never mix battery types or use new and used batteries in combination.
Always remove batteries from remote control if they are dead or if the remote control is not to be used for an
extended period of time. This will prevent battery acid from leaking into the battery compartment.
Remote
control
basics
,, Press ON/STANDBY
to turn the DVD/VCR on or off.
,, Press CH ^ or CH v to move through the channels one channel at a time.
The A/V/,
/ • are also used to navigate on-screen menu system.
,, You can directly access specific channels using numeric
keys.
,, Each press of DVD or VCR, switches the screen between the DVD screen (DVD mode) and the VCR screen
(VCR mode).
Operation
,, Aim the remote control at the remote sensor and press control buttons to
operate.
,, Operate the remote control within 30 ° angle on either side of the remote
sensor, up to a distance of approximately
7 meters (23 feet).
S
Approx.7
meters (23 feet)
Power Source
AC Outlet
Wider Hole
__
Polarized AC Cord Plug
(One blade is wider than the other.)
TO USE AC POWER SOURCE
Use the AC polarized line cord provided for operation on AC. Insert the AC
cord plug into a standard 120V 60Hz polarized AC outlet.
NOTES:
,, Never connect the AC line cord plug to other than the specified voltage
(120V 60Hz). Use the attached power cord only.
,, If the polarized AC cord does not fit into a non-polarized AC outlet, do not
attempt to file or cut the blade. It is the user's responsibility
to have an
electrician replace the obsolete outlet.
,, If you cause a static discharge when touching the unit and the unit fails to
function, simply unplug the unit from the AC outlet and plug it back in. The
unit should return to normal operation.
,, If the AC cord plug is plugged in for the first time, wait for approximate 3
minutes before operating the unit.
15
÷
2G00101A
P12-P21
15
_
3/7/05, 5:14 PM
Advertisement
Table of Contents
