Toshiba SD-V393SU Owner's Manual page 22

@ing the video channel
When a TV is connected with the 75 ohm coaxial cable only.
To view playback of a recorded tape or DVD disc, or to watch a
program selected by the VCR's channel selector, the TV must be set to
channel 3 or 4 (video channel).
O
)
(_(?(
POWER
VCR DVD
-- TV/VCR
--3
--4
÷
Press and hold 3 or 4 on the remote for 3
seconds in standby mode.
® ° The video channel will
Q OR start to flash for 3
@
seconds in the display
window.
\ /
--F F"
3-
/ \
Press POWER to turn on the DVD/VCR.
POWER
Press VCR DVD selector to select the VCR mode.
VCR The VCR indicator on the
DVD
i[_ front panel will light.
Turn ON the TV and set to CH 3 or 4 to corre-
spond with the channel selected in step 1.
Press TV/VCR to select the VCR position.
The VCR indicator will
TV/VCR
appear in the display
Q window.
VCI'4
Select any channel to receive a TV station in your area.
The channel number will appear on the screen for
about 4 seconds.
[] For a push-button TV tuner
If CH 3 or 4 corresponding to the video channel cannot
be tuned on your TV, proceed as follows: set the VCR
3/4 channel selector and the TV to CH 3 or 4, play
back a prerecorded tape and tune the TV to receive a
sharp color picture from the video cassette recorder.
Refer to your TV owner's manual for details.
Note:
if the unit does not operate properly, or No key operation
(by the unit and/or the remote control): Static electricity, etc.,
may affect the player's operation. Disconnect the AC power cord
once, then connect it again.
÷
22 _ 2/10/05, 7:32 PM