Basic Tv Connections; Optional Tv Connections - Toshiba SD-V55HTSU Owner's Manual

I I
Basic TV Connections
Make one of the following connections, depending on
the capabilities of your TV.
RF coaxial connection
Connect the RROUT jack on the DVDNCR Receiver to
the antenna in jack on the TV using the 75-ohm Coaxia!
Cable supplied (R).
_ote
if you use this connection, tune the TV to the
DVDNCR Receiver's RF output channel (CH 3 or 4).
How to set the DVD/VCR Receiver's RF output chan-
nel
When the DVD/VCR Receiver is turned off, press and
hold CH/PRESET (A/V) on the front panel for about five
seconds to change the RF output channel (CH 03 or
CH 04). "RF-03" or "RF-04" appears in the display win-
dow.
Audio/Video connection
Connect the DVDNCR VIDEO OUT jack on the
DVDNCR Receiver to the video in jack on the TV
using the supplied video cable (V).
Connect the Left and Right DVD/VCR AUDIO OUT
jacks on the DVDNCR Receiver to the audio
left/right in jacks on the TV (A) using the supplied
audio cables.
_ote
tf you use this connection, set the TV's source selector
to VIDEO.
Rear of TV
/
f
!
Rear of DVD/VCR Receiver
Optional TV Connections
_ote
DVD playback can also be done using the S-VIDEO OUT
and COMPONENT/PROGRESSIVE SCAN VIDEO OUT
connection options below. The tuner and VCR ONLY
output through the RROUT (R) or DVDNCR OUT (A,
V) jack. (See left)
S-Video Connection
Connect the S-ViDEO OUT jack on the DVDNCR
Receiver to the S-Video in jack on the TV using the
S-Video cable (S).
Connect the Left and Right AUDIO OUT jacks on
the DVD/VCR Receiver to the audio left/right in
jacks on the TV using the supplied audio cables
(A).
Component Video (Color Stream _') connection
Connect the COMPONENT/PROGRESSIVE SCAN
VIDEO OUT jacks on the DVDNCR Receiver to the
corresponding in jacks on the TV using Y Pb Pr
cables (C).
Connect the Left and Right AUDIO OUT jacks of
the DVD/VCR Receiver to the audio left/right in
jacks on the TV (A) using the supplied audio
cables.
Progressive Scan (ColorStream _ pro) connection
• If your television is a high-definition or "digital ready"
television, you may take advantage of the DVD/VCR
Receiver's progressive scan output for the highest
video resolution possible.
• If your TV does not accept the Progressive Scan for-
mat, the picture will appear scrambled if you try
Progressive Scan on the DVDNCR Receiver.
Connect the COMPONENT/PROGRESSIVE SCAN
VIDEO OUT jacks on the DVDNCR Receiver to the
corresponding in jacks on the TV using Y Pb Pr
cable (C).
Connect the Left and Right AUDIO OUT jacks of
the DVD/VCR Receiver to the audio left/right in
jacks on the TV (A) using the supplied audio
cables.
_otes
• Set the Progressive Scan to "On" on the DVD setup
menu for progressive signal, see page 21.
• Progressive scan does not work with the analog video
connections (yellow VIDEO OUT and S-VIDEO OUT
jack).
m m
I I