Pto(Bladeengage) Lever - Toro LX466 13AT61RH044 Operator's Manual

Systems Indicator Monitor / HourMeter
Oil
42.0 I]
PT0
(Blade Engage) Parking Brake
o (®) o
LCD
When the ignition key is rotated out of the STOP
position but not into the START position, the systems
indicator monitor displays the battery's output, in volts,
on its LCD for approximately five seconds, after which it
displays an hour glass and the hours of tractor
operation. Once the tractor is started, the monitor
continually displays an hour glass and the hours of
tractor operation on its LCD.
NOTE:
Hours of tractor operation are recorded any
time the ignition key is rotated out of the STOP position,
regardless of whether the engine is started.
The Indicator Monitor will also remind the operator of
maintenance intervals for changing the engine oil. The
LCD will alternately flash the recorded hours, "CHG"
and "OIL" for five minutes, after every 50 hours of
recorded operation elapse. The maintenance interval
lasts for two hours (from 50-52, 100-102, 150-152,
etc.). The LCD will also flash as described above for
five minutes every time the tractor's engine has been
started during this maintenance interval. Before the
interval expires, change the engine oil as instructed on
page 24 of this manual.
Brake
If the Brake light illuminates when attempting to start
the tractor's engine, press the brake pedal.
PTO(Blade Engage)
If the PTO light illuminates when attempting to start the
tractor's engine, move the PTO lever into the
disengaged (OFF) position.
Oil
It is normal for the Oil light to illuminate while the engine
is cranking during start-up, but if it illuminate's during
operation, while the engine is running, stop the
tractor immediately and check the crankcase oil level
as instructed in this Owner's Manual.
Battery
It is normal for the Battery light to illuminate while the
engine is cranking during start-up, but if it illuminate's
during operation, while the engine is running, the
battery is in need of a charge or the engine's charging
system is not generating sufficient amperage. Refer to
the MAINTAINING YOUR LAWNTRACTOR section of this
manual for the proper battery charging procedure or
have the charging system checked by an authorized
Toro service dealer.
PTO(BladeEngage) Lever
o.1'
OFF
PTO / BLADE
PTO
ENGAGE
The PTO (Blade Engage) lever is located on the left
side of the dash, next to the steering wheel. Move the
PTO (Blade Engage) lever forward to engage the
power to the cutting deck or other (separately available)
attachments; move the PTO (Blade Engage) lever
rearward to disengage the power to the attachments.
NOTE:
The PTO (Blade Engage) lever must be in the
disengaged (OFF) position when starting the engine.
15