Table of Contents
Advertisement
Using
Your
Display
for the First Time
When you turn on your LCD for the first time, you will need to set up the display for proper
operation
by scanning the television
spectrum for available channels.
Setting
up Television
Channels
Once the television
signal is connected
to the display, if you are connecting
directly to a wall jack
or antenna, you should scan the signal spectrum to weed out channels with insufficient
signal
strength. This will make it much easier to navigate through
the channels.
To scan the signal spectrum:
1.
Turn the display on using the POWER button.
2.
Press the MENU button to bring up the On-Screen
Display (OSD).
iiiill
.........................................................................
3.
Press the VOL _ button
until the Channel Settings menu
shows.
4.
Press the ENTER button to enter the menu.
S,
6.
Press the ENTER button
again to enter the System sub-
menu.
Press the CH _ and CH Y buttons
until the appropriate
system is highlighted,
then press the ENTER button to
select it.
Press MENU to return to the previous menu.
Press CH V until the Auto Scan sub-menu is highlighted
and then press ENTER to select it. The display wilt
_utomatically
scan all television
channels for those with
You can press MENU at any time to stop the
Advertisement
Table of Contents
