Using Your Display For The First Time; Setting Up Television Channels - PROTRON PLTV-37C User Manual

OMPLTV37C.book Page 10 Saturday, May 21, 2005 6:23 PM

Using Your Display for the First Time

When you turn on your LCD for the first time, you will need to set up the display for proper
operation by scanning the television spectrum for available channels.

Setting up Television Channels

Once the television signal is connected to the display, if you are connecting directly to a wall jack
or antenna, you should scan the signal spectrum to weed out channels with insufficient signal
strength. This will make it much easier to navigate through the channels.
To scan the signal spectrum:
1. Turn the display on using the POWER button.
2. Press the MENU button to bring up the On-Screen
Display (OSD).
3. Press the VOL
shows.
4. Press the ENTER button to enter the menu.
5. Press the ENTER button again to enter the System sub-
menu.
6. Press the CH
system is highlighted, then press the ENTER button to
select it.
7. Press MENU to return to the previous menu.
8. Press CH
until the Auto Scan sub-menu is highlighted
and then press ENTER to select it. The display will
automatically scan all television channels for those with
a signal. You can press MENU at any time to stop the
process.
button until the Channel Settings menu
and CH buttons until the appropriate
10
TV PARAMETERS
BRIGHTNESS
100
CONTRAST
50
BLACK LEVEL
50
SATURATION
50
HUE
50
COLOR TEMP ENTER
4 : 3 FULL
FORMAT
50
SHARPNESS
: Select MENU : Exit ENTER : Enter
CHANNEL SETTINGS
SYSTEM
ENTER
AUTO SCAN ON OFF
CH. EDIT ENTER
: Select MENU : Exit ENTER : Enter
CHANNEL SETTINGS
SYSTEM ANTENNA
AUTO SCAN CABLE
CH. EDIT CABLE-IRC
CABLE-HRC
: Select MENU : Exit ENTER : Enter