Heat Controller RAH-183G Owner's Manual page 12

Owner's Manual
Ins tallation Ins tructions
6 INSTALL THE CASE
IN THE WINDOW (cont.)
Adjust the leveling bolts and nuts against the
D
outside wall so that the case has a slight tilt
to the outside. Tighten nuts with an adjustable
wrench. Use a level; about a 1/2 bubble will
be the correct case slant to the outside.
Use a wood block (obtained locally) between
E
the leveling bolts and the wall if the wall is
weak or if the weight of the air conditioner
falls between the studs in the wall.
Extend the left and right accordion panels
F
to the vertical window sashes. Drill pilot
holes and attach the top and bottom corners
with 4 type D screws.
Type D
screw
Type D
screw
Room Air Heat Pump with R-410A
Top mounting rail
Type D
screw
Type D
screw
INSTALL SUPPORT BRACKETS
7 INSTALL SUPPORT BRACKETS
AND TOP WINDOW FOAM GASKET
AND THE FOAM TOP WINDOW
GA S K E T
A ttach the s upport brackets with two
A
type D s crews , one on each s ide.
Cut the foam top window gas ket to the
B Cut the top window foam gasket to the window
window width.
width.
Stuff the foam between the glas s and the
C Stuff the foam between the glass and the window
window to prevent air and ins ects from
to prevent air from getting into the room.
getting into the room .
10
10
Heat Controller, Inc.