Central Machinery 97099 Set Up And Operating Instructions Manual page 13

3. To operate, turn the Hand Wheel (S) counterclockwise 1/2 turn and move the
Front Vise Jaw (9) to the desired position. Then tighten the Front Vise Jaw
against the workpiece by turning the Hand Wheel clockwise. (See Figure C.)
HAND WHEEL (5S)
4. Setting up the Quick Vise for a straight (0°) cut:
• Loosen the Screws (H) and (G) of Front Vise Jaw (F).
• Turn the Hand Wheel (S) counterclockwise by half a turn and slide back the
Front Vise Jaw (9).
• Loosen Screw (A and B) and note that Screw (A) should be in the slot which is
parallel with the Rear Vise Jaw.
• Rear Vise Jaw at the scale side should be aligned with the zero (0) on the rule.
Tighten Screws (A and B). (See Figure D.)
G
. Setting up the Quick Vise an angle:
• Remove Screws (A and B) from base of the Rear Vise Jaw (22).
• Position (D) over (B) and attach the Screw and Washer (19 and 22) and attach Screw
(B).
• Attach Carriage Screw (17) onto Slot (C) through the curved slot in the Base (1).
• Align edge of the Rear Vise Jaw with the indexing rule and tighten Screws at (B and
C). (See Figure E.)
SKU 97009 For technical questions, please call 1-800-444-3353.
FrONT VISE JAW (9)
FIGUrE D
BASE (1)
H
9
OrIGINAL pOSITION (FOr 0° CUTTING)
HAND WHEEL (5S)
FIGUrE C
B
rEAr VISE JAW (22)
22
Note: Make
C sure "C" slot is
free of casting
A
flush so the
vise can be
positioned in
all angles.
D
Page 13