Specifications - Snapper 30215 Owner's Manual

SNAPPER "°
SPECiFiCATiONS
Maximum Surge Watts
..................
8,600 watts
Continuous Wattage Capacity ............ 5,600 watts
Power Factor ................................ 1.0
Rated Maximum Continuous AC Load Current:
At 120 Volts ......................... 46.6 Amps
At 240 Volts ......................... 23.3 Amps
Phase .................................. I-phase
Rated Frequency ......................... 60 Hertz
Fuel Tank Capacity .................... 7 U.S. gallons
ShippingWeight .......................... 163 Ibs.
GENERAL HAINTENANCE
RECOMMENDATIONS
The Owner/Operator
is responsible
for making sure that
all periodic maintenance tasks are completed on a timely
basis; that all discrepancies are corrected; and that the unit
is kept clean and properly stored. NEVER operate a
damaged or defective generator.
NOTE: Should you have questions about replacing
components on your Snapper generator, please call
1=800=317=7833 for assistance.
Ei=n_gi ne Maintenance
See engine owner's manual for instructions.
CAUTION
. Used motor oil has been shown to cause skin cancer in
certain laboratory animals.
. Thoroughly wash exposed areas with soap and water.
KEEP OUT OF REACH OF CHILDREN. DON'T
POLLUTE. CONSERVE RESOURCES. RETURN
USED OIL TO COLLECTION CENTERS.
Generator
Maintenance
Generator maintenance consists of keeping the unit clean
and dry. Operate and store the unit in a clean dry
environment where it will not be exposed to excessive
dust, dirt, moisture or any corrosive vapors. Cooling air
slots in the generator must not become clogged with snow,
leaves or any other foreign material.
NOTE: DO NOT use a garden hose to clean generator.
Water can enter engine fuel system and cause problems. In
addition, if water enters generator through cooling air slots,
some of the water will be retained in voids and cracks of
the rotor and stator winding insulation.Water and dirt
buildup on the generator internal windings will eventually
decrease the insulation resistance of these windings.
WARNING
WHEN ADJUSTING OR MAKING REPAIRSTOYOUR
GENERATOR
Disconnect the spark plug wire from the spark plug and place
the wire where it cannot contact spark plug.
WHEN TESTING FOR ENGINE SPARK
Use approved spark plug tester.
DO NOT check for spark with spark plug removed.
Generator
Cleaning_
• Use a damp cloth to wipe exterior surfaces clean.
CAUTION
o
o
o
DO NOT
expose generator to excessive moisture, dust, dirt,
or corrosive vapors.
DO NOT insert any objects through cooling slots.
Use a soft bristle brush to loosen caked on dirt or oil.
Use a vacuum cleaner to pick up loose dirt and debris.
Use low pressure air (not to exceed 25 psi) to blow
away dirt. Inspect cooling air slots and opening on
generator.These openings must be kept clean and
unobstructed.