Snapper LT180H331BV series I Safety Instructions & Operator's Manual page 54

Section 2 -OPERATING INSTRUCTIONS
2.4 STOPPING
2.4.3. STOPPING MOWER BLADE
1. Stop mower blade by moving blade engagement
lever down to the "OFF" position. See Figure 2.11.
BLADE
ENGAGEMENT
2.4.5. RELEASING PARK BRAKE
1. Fully depress clutch/brake pedal. Move park brake
lever "DOWN" to release park brake. Release
clutch/brake pedal. See Figure 2.13.
PARK BRAKE
LEVER
OFF
FIGURE 2.11
WARNING
Once blade is disengaged, it should come to a
complete stop in 5 seconds or less. If the blade
continues to rotate after 5 seconds, the blade brake
must be adjusted. Refer to Section "BLADE BRAKE
ADJUSTMENT" for adjustment procedures or return
machine to dealer for adjustment. DO NOT CONTINUE
to operate mower until blade brake is properly
adjusted.
FIGURE 2.13
2.5. CUTTING HEIGHT ADJUSTMENT
1. Depress lock button on cutting
adjustment lever. See Figure 2.14.
DEPRESS
LOCK BUTTON m
height
2.4.4. SETTING PARK BRAKE
1. Fully depress clutch/brake pedal.
2. Move park brake lever up into slot. See Figure
2.12.
PEDAL ALL PARK BRAKE
THE WAY DOWN
MOVE PARKBRAKE
LEVER"UP'TO ENGAGE
PARKBRAKE
FIGURE 2.12
LOWEST CUT
FIGURE 2.14
2. Raise or lower deck to any of s=x positions as
desired Release lock button.
IA A I
DO NOT park machine on slopes.
10