Functional Description; Specifications; Components And Controls; Initial Tool Set Up/ Assembly - Central Pneumatic 97855 Set Up And Operating Instructions Manual

FUNCTIONAL DESCRIPTION

Specifications

Cup Capacity
Operating Air Pressure
Maximum Air Pressure
Air Consumption
Air Inlet
Nozzle Size
Needle Size
Draw Type
Spray Pattern

Components and Controls

Pattern Control Knob (10)
Fluid Control
Knob (16)
Trigger (7)
Cup
Locking
Lever (32)
Air Inlet (20)
Cup Mounting
Yoke (33)
Cup (31)
Fig. 1
SKU 97855
1 Quart
60 PSI
115 PSI
10 SCFM @ 60 PSI
1/4" -18 NPS
0.07"
1/8" dia.
Siphon Feed
Horizontal, vertical,
round, diagonal
Air Cap (1)
For technical questions, please call 1-800-444-3353.
INITIAL TOOL SET UP/
ASSEMBLY
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.

Unpacking

When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown throughout the manual as soon as
possible.
• This air tool may be shipped with a
protective plug covering the air inlet.
Remove this plug before set up.

Air Supply

Use only clean, dry, regulated,
compressed air to power this
tool. Do not use oxygen,
carbon dioxide, combustible
gases, or any other bottled
gas as a power source for this
tool.
TO PREVENT
EXPLOSION:
Page 7