Blower Tube Assembly; Bag Assembly - Poulan Pro BVM200 LE Instruction Manual

A
dli WARNING:
Stop engine and be sure
the impeller blades have stopped turning be-
fore openh_g the vacuum h_let door or at-
tempting to insert or remove the vacuum or
blower tubes. The rotating blades can cause
serious injury. Always disconnect the spark
plug before performing maintenance or ac-
cessing movable parts.
_WARNING:
If you receive your unit
assembled, check each step to insure your
unit is properly assembled and all fasteners
are secure. Follow all safety information in
the manual and on the unit.
• A standard screwdriver is required for as-
sembly.
BLOWER TUBE ASSEMBLY
1. Align the rib on the blower tube with the
groove in the blower outlet; slide the tube into
place.
NOTE: Knob must be loose enough to allow
blower tube to be inserted in blower outlet.
Loosen knob by turning counterclockwise.
Blower
Outlet Blower Tube
_*Groove_ "_ Rib ............
2. Secure the tube by turning the knob clock-
wise.
3. To remove the tube. turn the knob counter-
clockwise to loosen the tube; remove the
tube.
VACUUM BAG ASSEMBLY
1. Open the zipper on the vacuum bag and in-
sert the elbow tube.
2. Push the small end of the elbow tube
through the small opening in the bag.
Elbow
Tube
Small
Opening
-\
Zipper
Opening Rib
NOTE: Make sure edge ofthe small opening
is flush against the flared area of the elbow
tube. and the rib on the elbow tube is on the
bottom.
3. Close the zipper on the bag. Make sure the
zipper is closed completely.
4. Remove blower tube from engine.
-5-
Rib
__roove
5. insert the elbow tube into the btower outlet.
Make sure elbow tube rib is aligned with the
blower outlet groove.
6. Turn knob clockwise to secure elbow tube.
VACUUM TUBE ASSEMBLY
_' WARNING : Stop engine and be sure
the impeller blades have stopped turning be-
fore opening the vacuum inlet door or at-
tempting to insert or remove the vacuum or
bJower tubes. The rotating btades can cause
serious injury.
1. Align the lower vacuum tube as shown.
Push lower vacuum tube into upper vacuum
tube.
Upper
Tube
Lower Vacuum Tube
2. insert the tip of a screwdriver into the latch
area of the vacuum inlet.
Latch _ Blower
Area Outlet
Latch Area
_1_ Vacuum
Inlet Cover
3. Gently tilt the handle of tt_e screwdriver to-
ward the back of the unit to release the latch
while pulling up on the vacuum inlet cover
witt_ your other hand.
4. Hold the vacuum inlet cover open until upper
vacuum tube is instafled.
Vacuum inlet _
Retaining Post X_/,,_ il)t_