Page 1
Tout défaut de le faire pourrait entraîner des blessures graves. Poulan PRO 9335 Harris Corners Parkway Charlotte, NC 28269 115351227 Rev. 6 11/30/10 BRW Instruction Manual BVM210VS Poulan PRO 850 Matheson Blvd. West...
30 feet (10 meters) when starting or operating unit. Do not point blower nozzle in the direction of people or pets. Always stop unit and disconnect spark plug before cleaning or servicing.
Keep children, bystanders, and animals away from work area a minimum of 30 feet (10 meters) when starting or operating unit. Do not point the blower nozzle in the direc- tion of people or pets. HANDLE FUEL WITH CAUTION, IT IS...
Have all maintenance other than the rec- ommended procedures described in the in- struction manual performed by an autho- rized service dealer. Use only recommended Poulan PRO re- placement parts; use of any other parts may void your warranty and cause damage to your unit.
A standard screwdriver is required for as- sembly. BLOWER TUBE ASSEMBLY 1. Align the rib on the upper blower tube with the groove in the blower outlet; slide the tube into place. NOTE: Knob must be loose enough to allow blower tube to be inserted in blower outlet.
Page 6
2. Remove the vacuum tubes by turning the tubes clockwise. 3. Close the vacuum inlet cover and make sure it is latched closed. 4. Reinstall the blower tubes (see BLOWER TUBE ASSEMBLY). VACUUM BAG SHOULDER STRAP ADJUSTMENT WARNING:...
THROTTLE POSITION LEVER The THROTTLE POSITION LEVER is de- signed to allow setting engine speed during blower use only. To avoid causing damage to the unit, DO NOT attempt to use the throttle position lever during vacuum use. OPERATING TIPS...
2-cycle air-cooled engine oil designed to be mixed at a ratio of 40:1. Poulan PRO brand synthetic oil is recommended. Mix gasoline and oil at a ratio of 40:1. A 40:1 ratio is obtained by mixing 3.2 fluid ounces (95 ml) of oil with 1 gallon (4 liters) of unleaded gasoline.
If any dealer other than an authorized service dealer performs work on the product, Poulan PRO may not pay for repairs under warranty. It is your re- sponsibility to maintain and perform general maintenance.
Page 10
The warranty on this unit does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, the operator must maintain unit as instructed in this manual. Various adjust- ments will need to be made periodically to properly maintain your unit.
Page 11
CARBURETOR IDLE SPEED ADJUSTMENT The carburetor has been carefully set at the factory. Adjustments may be necessary if you notice any of the following conditions: S Engine will not idle when the throttle is re- leased. To adjust idle speed: Allow engine to idle.
Page 12
WARNING: Always stop unit and disconnect spark plug before performing any of the recommended remedies below other than remedies that require operation of the unit. TROUBLE CAUSE Engine will not 1. Engine flooded. start. 2. Fuel tank empty. 3. Spark plug not firing. 4.
This is a limited warranty within the meaning of that term as defined in the Magnuson- -Moss Act of 1975. The policy of Poulan PRO is to continuously improve its products. Therefore, Poulan PRO reserves the right to change, modify, or...
Page 14
ON OR MODIFIED PARTS: The use of add- - on or modified parts can be grounds for disal- lowing a warranty claim. Poulan PRO is not li- able to cover failures of warranted parts caused by the use of add- -on or modified parts.