Table of Contents
Advertisement
ASSEMBLY / PRE-OPERATION
Read these instructions and this manual in its entirety before you attempt to assemble or operate your new snow thrower.
Your new snow thrower has been assembled at the factory with the exception of those parts left unassembled for shipping
purposes. All parts such as nuts, washers, bolts, etc., necessary to complete the assembly have been placed in the parts
bag. To ensure safe and proper operation of your snow thrower, all parts and hardware you assemble must be tightened
securely. Use the correct tools as necessary to ensure proper tightness.
REMOVE
SNOWTHROWER
FROM CARTON
t.
Remove all accessible loose parts and parts boxes
from carton.
2.
Cut down all four corners of carton and lay panels
flat.
3.
Remove all packing materiars except plastic tie holding
speed control rod to lower handle.
4.
Remove snow thrower from carton and check carton
thoroughly for additional loose parts.
HOW TO SET UP YOUR SNOW THROWER
TOOL BOX (See Fig. 8)
A toolbox is provided on your snow thrower. The toolbox
is located on top of the belt cover. Store the extra shear
bolts, nuts and multi-wrench provided in parts bag in the
toolbox.
NOTE: The multi-wrench may be used for assembly of the
chute rotator head to snowthrowerand
making adjustments
to the skid plates.
UNFOLD UPPER HANDLE
1.
Raiseupperhandletotheoperatingpositionandtighten
handle knobs securely.
UPPER
HANDLE
HANDLE
KNOB
LOWER
SPEED
CONTROL
I
1
INSTALL SPEED CONTROL ROD (See Figs. 1 and 2)
1.
Remove plastic tie securing rod to lower handle.
2.
Insert rod into speed control bracket and secure with
retainer spring.
FIG. 1
-SPEED
CONTROL
ROD
RETAINER
SPRING
SPEED
CONTROL
CONTROL
BRACKET
LEVER
FIG. 2
Advertisement
Table of Contents
