Water Supply - Fisher & Paykel AquaSmart WL70T60C Installation Instructions Manual

Water supply

This clothes washer should be plumbed into both a hot and cold water supply otherwise some
cycles may not function correctly.
For best operating conditions your hot water should be approximately 65˚C. Your hot water
should not exceed 75˚C or your cold water exceed 5˚C. Temperatures above these may cause a
fault or cause damage to the machine.
If you have an uncontrolled water-heating source (eg. a wet back or solar heating) you should
have a tempering device fitted. This will ensure the hot water temperature remains within
safe limits. For the most suitable type of tempering device we recommend you contact a local
plumber or plumbing supply merchant.
Inlet Water Static Pressure of between psi (0kPa) and 50psi (MPa) is recommended.
(If using a header tank then the top of the header tank must be at least  metres above the top of
your clothes washer).
Minimum flow rate from the tap supplying the clothes washer should be greater than 6 litres/min
(assumes .7mm (/ inch) diameter pipes).
Minimum height of taps to clear the top of the machine is 50 mm.
Inlet hoses
Connect the straight ends of the white inlet hoses to the
1
taps (there are washers fitted in both ends).
Connect the elbow ends of the white inlet hoses to the
2
machine inlet valves. Inlet valves are marked on the back of
the machine.
H=Hot
Electrical
This appliance must be supplied with a 0V - 40V, 50Hz, sinusoidal, 450W electrical supply.
Installation instructions
C=Cold
Tap end Machine end
Fig.3 Inlet hose ends