Settings Menu; Temperature Adjust / Aqua Plus - Fisher & Paykel AquaSmart WL70T60C Installation Instructions Manual

Settings menu

6
After using your AquaSmart™ washer you may wish to fine-tune some of the options to suit
your individual needs. Any options changed in this menu is a permanent change, unless 'Reset
Defaults' is selected (refer to page 9).
To access the Settings Menu:
Turn your AquaSmart™ washer on.
1
Scroll, to the right, through the wash cycles until you reach the Settings Menu.
2
Press SELECT to enter the menu.
3
Temperature Adjust
The wash temperatures can be adjusted if you think they are too hot or
too cold.
Access the Settings Menu (refer above).
Scroll to the TEMPERATURE option, and press SELECT.
Use the SCROLL button to move through the boxes to decrease or increase
the wash temperature (the numbers in the boxes are in degrees). Each
movement is approximately °C.
Press SELECT to confirm your selection and return to the Settings Menu.
Aqua Plus
Activating this option adds additional water to the Aqua rinse in a High
Efficiency wash cycle. This will give you a little extra rinsing for those with
sensitive skin.
Access the Settings Menu (refer above).
Scroll to the AQUA PLUS option, and press SELECT.
Scroll to highlight either AQUA PLUS rinse ON or AQUA PLUS rinse OFF.
Press SELECT to confirm your selection and return to the Settings Menu.