NordicTrack E5.7 NTELO5011.0 User Manual page 8

5. 5
Tip: Avoid pinching the Upper Wire (110). Set
the Upright (4) on the Frame (1).
Attach the Upright (4) with four M10 x 25mm
Button Screws (131) and four M10 Split Washers
(105).
110
131
4
Avoid pinching the
Upper Wire (110)
,
Using a plastic bag to keep your fingers clean,
apply some of the included grease to the Pivot
Axle (35) and to two 16mm Wave Washers (54).
Insert the Pivot Axle (35) through the Upright (4)
and center it. Tip: it may be helpful to use a
rubber mallet.
Identify the Right Upper Body Leg (60), which
is marked with a "Right" sticker, and orient it as
shown.
Slide a 16mm Wave Washer (54) and the Right
Upper Body Leg (60) onto the right side of the
Pivot Axle (35).
Repeat these actions for the Left Upper Body
Leg (46).
Tighten an M8 x 13mm Button Screw (82) and
an M8 Washer (97) into each end of the Pivot
Axle (35) at the same time.
;5 Grease
54
60
97
82
8