NordicTrack AudioStrider 990 PRO NTEL09811.2 User Manual page 10

10. Apply grease to a Short Axle (149) and to two
M8 x 22mm Washers (97).
Next, tighten an M8 x 23mm Button Screw (82)
and an M8 x 22mm Washer (97) a few turns into
the Short Axle (149).
While a second person holds the front end of
the Right Link Arm (59) inside the bracket on the
Right Upper Body Leg (60), insert the Short Axle
(149) through both parts.
Tighten another M8 x 23mm Button Screw (82)
and an M8 x 22mm Washer (97) a few turns into
the Short Axle (149). Then, tighten both Button
Screws at the same time. time.
Repeat this step on the other side of the
elliptical.
10
59
149
Grease
97
11. Identify the Right Inner and Outer Leg Covers
(83, 69), which are marked with "Right" stickers,
and orient them as shown.
Press the Right Inner and Outer Leg Covers (83,
69) together around the Right Upper Body Leg
(60).
Attach the Right Inner and Outer Leg Covers
(83, 69) to the Right Upper Body Leg (60) with
an M4 x 16mm Screw (101). To avoid damag=
ing the plastic, do not overtighten the Screw.
Attach the Left inner and Outer Leg Covers
(72, 70) in the same way.
11
10