Fisher & Paykel RF201A Installation Instructions And User Manual page 15

6. What to do if your product is unstable
Gently push the refrigerator back until the rear rollers
E
contact floor.
Measure the gap under the front foot, which has come
off the floor.
Obtain some solid packing material (hardwood, plastic
etc) which fits firmly into the gap under the foot.
Note: Do not use metallic materials that may corrode and
stain or damage floor coverings.
Wind both front feet up and roll the product out of
F
position.
Place the packing material in the location diagonally
opposite the front roller that lifts off the floor.
Make sure the packing material stays in place when the
product is pushed back into position.
Ideally, the packing material is large enough to rest
against the back wall so as to prevent it moving when
the cabinet is pushed into position.
Wall behind refrigerator
Roll the refrigerator back into position and adjust front feet as per step D. (Check alignment and
G
door closing action are satisfactory).
Make small adjustments to front feet where necessary.
Check that the product is stable (all 4 feet are on the floor). If not return to step E and repeat
steps F and G.
Installation instructions
Packing material goes under rear roller
diagonally opposite front foot that lifts
If this foot lifts off the floor when pushing
gently on the top front of the refrigerator
Fig.14 Stabilizing your refrigerator
Example only
Un-level floor
This foot lifts off the floor when
top front is gently pushed back
Fig 13.Unstable refrigerator
13