Assembly And Setup - MTD RZT Series Operator's Manual

Assembly & Set-Up
3
Contents of Crate
• One Lawn Tractor •
• One RZT Tractor Operator's •
Manual
One Oil Drain Tube
One Briggs & Stratton Engine
Operator's Manual
• One Deck Wash Hose Coupler
• One Product Registration Card
TRACTOR P REPARATION
Remove the upper crating material from the shipping
pallet, and cut any bands or tie straps securing the tractor
to the pallet.
Use the lift handle to raise the deck to its highest position.
Engage the transmission bypass rods on each side of the
tractor; then carefully roll the tractor off the shipping
pallet. Disengage the bypass rods. See Figure 3-1.
RH Transmission Pull out
Bypass Rod Bypass Rod
Then Lower
in Slot
k._,3
Keystone
Slot
Figure 3-1
Remove the deck wash system nozzle adapter from the
manual bag and store for future use.
Install Operator's Seat
The operator's seat was partially inserted into the seat
pivot bracket for shipping purposes. To install the seat
proceed as follows:
1. Cut any straps securing the seat assembly and the
drive control levers to the tractor. Remove any packing
material.
NOTE: The seat is partially inserted into the slots of the seat
pivot bracket. If the seat does not become disengaged from
the pivot bracket when removing the packaging material, the
pivot bracket may be pivoted upward and the seat pushed
into place as described in step 6. If the seat does disengage the
pivot bracket, install the seat as instructed in steps 2 thru 6.
2. Pivot the seat pivot bracket partially upward. Refer to
Figure 3-2.
3. Note the grooves in the seat adjust spacers attached
to the bottom of the seat, then lift the seat and
position above and to the rear of the pivot bracket.
4. Align the grooves in the seat adjust spacers with the
sides of the adjustment slots in the pivot bracket.
S.
6.
Slide the seat adjust spacers into the slots of the pivot
bracket.
Continue to push the seat forward in the pivot bracket
until the front/left shoulder bolt of the seat assembly
passes forward of the stop bracket on the seat pivot
bracket. See Figure 3-2.
Seat
Seat
Ad
ShoulderBolt
Sto Bracket-_
Seat
Bracket
SeatAdjust
Lever
Figure 3-2
Refer to "Adjusting Operator's Seat" in Maintenance &
Adjustments for seat adjustment instructions.
Position DriveControllevers
The drive control levers of the tractor are lowered for
shipping purposes. The flange lock nuts, hex screws, and
flat washers that normally secure the control levers in
their operating position are unfastened and installed in
the slotted holes of the control levers for shipment. The
control levers must be repositioned to operate the tractor.
To reposition the control levers for operation, proceed as
follows:
1. Remove the hex screw, flat washer, and flange lock nut
from the slot of one of the drive control levers.
2. Lift and swing that control lever upward until the
slotted hole in the lever bracket aligns with one of the
holes in the pivot bracket. Refer to Figure 3-3.
3. Slide the flat washer onto the hex screw. From the
outside, insert the hex screw w/washer through the
control lever slot and the hole of the pivot bracket.
Secure with the flange lock nut. Refer to Figure 3-3.