Advertisement
ii
i
SECTION 2: FINDING YOUR MODEL NUMBER
This Owner's Guide is an important part of your new chipper shredder.
It will help you assemble, prepare and
maintain your chipper shredder.
Please read and understand what it says.
Before you start to prepare your chipper shredder for its first use, please locate the model plate and copy the
information from it in this Owner's Guide. The information on the model plate is very important If you need help
from your dealer or the MTD customer support department.
• Every chipper shredder
has a model plate.
You can locate it by standing behind the unit in the operating
position and looking down at the frame next to the engine.
° The model plate will look like Figure 1.
I
1
XXX-X-XXX-X-XXX
I
Mro /2MTO
PROOOCTS
,.O
_l_"Jil_lt_l'.
CLEVELAND,
OHIO 441_
This is where your model number will be.
This is where your serial number will be.
Copy the model number here:
Copy the serial number here:
Figure 1
SECTION
3: CALLING
CUSTOMER
SUPPORT
If you are having difficulty assembling
this product or if you have any question regarding the controls, operation or
maintenance
of this chipper shredder,
please call the Customer
Support Department.
You can reach them by
calling:
1-800-800-7310
Before you call, make sure that you have both your model and serial number ready.
By having the model and
serial number
ready, you help the Customer
Support Representative
give you faster service.
To find your units
model and serial number, see SECTION 2: FINDING YOUR MODEL NUMBER.
SECTION
4: UNPACKING
INSTRUCTIONS
REMOVE UNIT FROM CARTON
• Remove staples, break glue on top flaps, or cut tape at carton end and peel along top flap to open carton.
• Remove loose parts included with unit (i.e., owner's manual, etc.).
• Cut along dotted lines and lay carton down fiat.
• Remove packing material.
° Rol! or slide unit out of carton. Check carton thoroughly for loose pads.
•
,i
i
i
SECTION
5: SET-UP
INSTRUCTIONS
This guide covers models
462B 5 H.P. thru 465A 8 H.P. chipper shredders.
Much of this guide pertains
to
both models.
However, there are some areas where only one model is covered.
Use only the information
that is appropriate
for your model.
4
f
Advertisement
