MTD 600-Series L Style Operator's Manual page 17

Auger Shaft
At least once a season, remove the shear pins from the auger
shaft. Spray lubricant inside the shaft and around the spacers and
the fla nge bearings found at either end of the shaft.
See Fig. 6-3.
.......................... ....................... ..................... ................... ...................
J
Figure 6-3
Adjustments
Shift Cable
If the full range of speeds (forward and reverse) cannot be
achieved, refer to the figures to the right and adjust the shift
cable as follows:
1. Place the shift lever in the fastest forward speed position.
2. Loosen the hex nut on the shift cable index bracket. See
Fig. 6-4.
F
Figure 6-4
3. Pivot the bracket downward to take up slack in the cable.
4. Retighten the hex nut.
Auger Control
Refer to the Assembly and Set-up section for instructions on
adjusting the auger control cable.
ChuteAssembly
Refer to the Assembly and Set-up section for instructions on
adjusting the skid shoes chute assembly.
Skid Shoes
Refer to the Assembly and Set-up section for instructions on
adjusting the skid shoes.
SECTION 6 -- MAINTENANCE & ADJUSTMENTS
17