Advertisement
/
above information on
how to use the Locator Code
Button for Programming,
For most homes this step would
not be needed
but for your
information:
Up to 9 different remote locator
address codes can be set on which the
TV can send out its "homing" signal.
This is done in case there is more than
one TV (with a remote locator)
_resent, and you want only one
specific remote to be signaled when the
TV is turned ON.*
To set a Locator Address Code:
_With
TV turned
the
ON, press
LOCATOR CODE button on the
remote. (Also be sure the TV
SYSTEM button on the remote has
been pressed.)
! You will need a pencil or pen to press
the recessed button.
The TV shows the present Remote
Locator Code.
,_
Press
number button (0-9) on
any
the remote to set orchange the
LocatorCode.
Remember, if batteries are
replaced the Locator Code
will need to be reentered.
When setting the Locator Code if any
button, other than the number buttons,
are pressed the remote will return to
its normal operation mode.
*For owners who live in an apartment
(townhouse or condominium)
complex, this task may be necessary
since the remote locator's signal can
be sent and detected directly through
adjoining walls.
_7
Advertisement
