Advertisement
our TV remote can be set to
ork your VCR or Cable
Converter
by what is called
the
SEARCH
method.
," 1 _,_
Press the POWER button on
the VCR or Converter to turn the
unit ON.
If the "REMOTE CODE" number
method shown in the previous sec-
tion did not set your remote to
work your VCR or Converter, then
follow the easy steps listed below.
Please read through steps 1-4
before beginning.
c-a- fm3
"X,,_
Stand at least six feet away
from the front of the VCR or
Converter.
Point the remote toward the unit.
HOLD DOWN the SURF and the
desired System (VCR or CBL-
Converter) buttons at the same
time. KEEP HOLDING BUT-
TONS DOWN.
<_
Watch the Channel
Indicator
on the unit.
Channel
Numbers
will SCAN UP
when the unit has been identified.
This may take up to two minutes.
<_
Release the SURF and System
(VCR or CBL) buttons as soon
as channel numbers start to scan
up. The code has been identified
and the remote_is ready to operate
with the VCR or Converter.
,
0
'1
Remember, a minute or
! two can seem very long, but
the code should be located within
two minutes.
Don't let the VCR scan up more
than five channels. If you do the
remote may pass up the right code
and another two minute search
cycle will have to be repeated.
If no channel change happens
within two minutes, repeat steps 1-
4. Should a channel change still
not occur, the remote will not
work with the desired unit.
CABLE CONVERTER
Don't let
Six Feet
(minimum)
28
Advertisement
