Antenna Connection; Connecting The Power Cord; Basic Cable Tv Connection - Magnavox 26MF605W series Owner's Manual

ANTENNA CONNECTION
A ombination antenna receives normal
broadcast channels (VHF 2-13 and UHF
14-69). "Your connection is easy because there is
only one 75 L_antenna jack on the back of your TV,
and that's where the antenna goes.
If your antenna has a round cable
(75 _) on the end, then you're ready to
connect it to the LCD TV. If your
antenna has flat, twin°lead wire (300_),
you first need to attach the antenna wires
to the screws on a 300-75L_ adapter(not
supplied).
Connect the antenna (or adapter) to the
TV jack (marked 75 L_) on the rear of the
LCD TV. If the end of the antenna wire is
threaded, screw it down finger tight.
Outdoor or indoor Al_tenna
(Combination VHF/UHF)
Twindeadwire
to 300-75_ adpter
or
with 75_
cable
..................................................................
Select weak signal mode via the smart
picture settings in case your antenna
connection is showing a lot of noise or
strange patterns.
BASIC CABLE TV CONNECTION
our Cable TV signal into your home may
be a single, 73 L_cable. If so, this
connection is very simple. Follow the step
below to connect your Cable TV signal to
your new LCD TV,
Connect
the cable TV signal to the TV
jack (marked 75 _) on the rear of the
LCD TV. Screw it down finger tighL
Rear Jack panel of Television
The Cable TV singal
from Cable Company
75Q coaxial cable
CONNECTING THE
POWER
CORD
Complete other connections prlor to
connecting the power cord.
Connect the power cord to the AC IN
connector of the LCD TV,
Connect the other plug of the power
cord to a wall outlet,
0
Wall outlet
AC IN
9
MAG-26 eng0104.indd 9 _ 1/6/2005 10:30:37 I