Surface Burners - Magic Chef CPL1100BDW Owner's Manual

• DO not attempt to service this appliance yourself yo u know what caused the problem. Always replace
unless directed tod0 s0 in this manual or the chart a blown fuse with one of the correct amperage, do
below, Refer all other servicing to a qualified servicer not use a substitutel
or call us at 1,800,688.9900. • Always disconnect power to unit before any servicing
• LOCate and mark circuit breaker O r fuse: Neve r tripping circuit breaker to the OFF position or by
replace a blown fuse or reset a circuit breaker untit removing the fuse:
PROBLEM' CAUSE'
CORRECTION
Surface burner fails to light, a. power supply not connected
b. air in the gas line
c. clogged burner port(s)
d. surface control not completely
turned to the LITE position or turned
too quickly from the LITE position
e. power failure (pilotless ignition)
Burner flame is uneven, a: clogged burner port(s) a: clean ports with straight pin
Surface burner flame lifts off port
or is yellow in color.
Oven burner fails to light,
Popping sound heard when
burner extinguishes.
a. air/gas mixture not proper
NOTE: Some yellow tipping with LP
gas is normal and acceptable.
a: powei supply not cOnnected
bl power failure
c. oven incorrectly set
a. connect power, check circuit
breaker or fuse box
b. see page 5 for instructions on
bleeding air from the gas line
c. clean ports with straight pin or small
metal paper clip
d. turn control to the LITE position until
the burner ignites, then turn control
to desired flame size
e. see page 5 to light burner during a
power failure
This is a normal sound that occurs with some types of gas when a hot burner is
turned off. The popping sound is not a safety hazard and will not damage the
appliance.
a, oven not preheated or set at correct
temperature;
bl used incorrect rack position
is uneven, c, incorrect use of aluminum foit
° food cooks unevenly: d. oven bottom incorrectly replaced d. replace oven bottom correctly
• food is underdone or e: oven thermostat sensing device is e, reinstall thermostat sensing device
overdone: out of the holding clip(s),
a. call serviceman to adjust burner
NOTE: Be sure installer properly
adjusted range at time of installation.
a: connect power; check circuit
breaker Or fuse box
b. oven will not oPerate during a power
failure
C: See page 7