Remote Control; Vcp To Vcr Dubbing - Sears LXI series 580.55114490 Owner's Manual

REMOTE CONTROL
Aim the remote control at the receiver on the trullt
panel of the VCP.
NOTES:
1. If the range is short, try new batteries.
2. An object in between the VCP and remote
control may block the invisible light beam and
operation will not be possible.
• Be sure to install two "AAA" size batteries (not
supplied) before use.
• Be aware of the polarity.
VCP TO VCR DUBBING
pO_R EJECT
STILL A,REPEAT
- "POWER" ON/OFF Button
"EJECT" Button
"PLAY" Button
"STOP" Button
"REW(ind)" Button
"F(ast) F(orward)" Button
"A.REPEAT" Button
"STILL" Button
, "TRACKING" Buttons
If you wish to exchange or copy some of your friend's favorite home recordings, the following instructions can
be used to connect one VCP to another VCR for this purposed.
AUDIO IN VIDEO4N VHF OUT
AUDIO OUT VIDEO OUT
VHF Antenna terminal
TV set(Used for monitoring)
1.Connect VIDEO OUT/AUDIO OUT of VCP 1 to
VIDEO IN/AUDIO IN of VCR 2.
2. Set Input Select Button of VCR 2 to AN mode.
3. Play the tape on VCP 1 and record it on VCR 2.
NOTE: If you connect the "VHF/UHF OUTPUT"
connector of VCR 2 to the "TV ANT" connector, as
illustrated, and press the "VCR/TV" selector to turn
the indicator on, the picture being dubbed by VCR 2
can be monitored.
-18-