Table of Contents
Advertisement
3. Connect the 75-ohm Coaxial Cable with Antenna
Adaptor
to "OUT
TO "IV" on the RF Converter
Unit,
4. Connect the other end to the VHF antenna terminal
on the TV, as illustrated.
5, Connect the Connector Cable from RF Converter
Unit to "AV
OUT"
jack on the Video Camera/
Recorder,
6. Turn on the TV and set to Channel 3 unless Channel
3 is one of the TV stations in your area. If Channel
3 is used in your area, set your TV to Channel 4.
7. Set the RF Channel Selector on the RF Converter
Unit to "CH3"
or "'CH4"' to match the channel
selector on your TV.
This is the Video Camera/
Recorder channel on your TV set. Your TV receiver
must be tuned to this channel any time a video
cassette is played back on the Video Camera/
Recorder.
RF Channel
Selector
8. Press "EJECT"
Button on the Video Camera/
Recorder and then insert the cassette.
9. Set "VCR/CAM"
Select Switch to "VCR'"
po-
sition.
10. Press "POWER"
ON/OFF Button on.
11, Press "PLAY"
Button,
12. After playing press "STOP"
Button.
"POWER"
ON/OFF
Button
"VCR/CAM"
Select Switch
"EJECT"
Button
"PLAY"
Button
"STOP"
Button
NOTE: If you want to watch a "IV program with Video Camera/Recorder
connected as illustrated, press
"POWER"
ON/OFF Button of the Video Camera/Recorder off, or disconnect the connector cable of RF Con-
verter Unit from "'AV OUT" jack on the Video Camera/Recorder.
Example 2: If your TV has "VIDEO
IN" and "AUDIO
IN" jacks,
To "AV OUT"
Audio/Video
Output
Cable
(Accessory No. 4)
/
N
f_
To "VIDEO
IN" 00
To "AUDIO
IN'"
(Yellow)
_J
(White)
1. Connect
the Audio/Video
Output
Cable (Accessory
3. Turn on TV.
No. 4) to "AUDIO
IN"
and "VIDEO
IN"
of your
4. Perform
same
procedures
in Steps 8 through
12 of
TV.
"Example
1" above.
2. Connect
the other
end of the Audio/Video
Output
Cable to "AM OUT"
of your Video
Camera/Recorder.
- 33-
Hide quick links:
Advertisement
Table of Contents
