Adjusting The Cutting Depth - Drill Master 68341 Manual

adjusting the Cutting Depth

1
Place the router on a flat wood
surface. Unlock the Lock Lever (30).
Lock Lever
(30)
3
Slide the Scale Ring until the "0" aligns with
the index line (vertical mark) on the Main
Housing. Unlock the Lock Lever. Each line on
the scale raises or lowers the bit by 1/64".
Index Line
(vertical mark on
Main Housing)
Scale Ring
attaching Guide
To attach the Guide (24) when making straight cuts:
1. Loosen the four Wing Nuts (27 and 37).
2. Slide the Guide Poles (28) on the Guide (24)
into the slots on the Base of the Router
with the Guide facing the workpiece.
3. Adjust the distance between the router bit
and the Guide to the desired setting.
4. Tighten the Wing Nuts (27 and 37).
SKU 68341 For technical questions, please call 1-800-444-3353.
2
Rotate the Main Housing until the
tip of the bit touches the workpiece
surface. Lock the Lock Lever.
Main
Housing
(5)
4
While holding the Base up from the
surface, rotate the Main Housing to
raise or lower the bit until the index line on
the housing aligns with the desired depth
on the scale ring. Lock the Lock Lever.
Guide (24)
Wing Nuts (27)
Spindle
Lock Lever
(30)
Wing
Nuts (37)
Base
(45)
Guide Poles (28)
Page 9